Idiomas disponibles
Idiomas disponibles
8.- FITTING THE CENTRAL
COVERS.-
Take the front (22L) and rear (22R)
covers and position them on the main
post (91), Fig.10. Now use the screws
(4) to attach them to the post.
9.- FITTING THE FOCUS BAR
SIDE COVERS.-
Take the covers (8R), marked on the
inside with the letter "R", and position
them at the spindle end with the bars
on the right hand side, as shown in
Fig.10. Now use screws and (4-21) to
attach them.
Carry out the same procedure at the
other end of the bar using the covers
(8L) marked on the inside with the
letter "L".
10.- FITTING THE FOCUS BAR
SIDE COVERS TO THE FOOT
BARS.-
Next fit the footrest covers (27F) &
(27R) with the bottom of the joints on
the right side, Fig.10. Use screws (28)
to screw them together.
Then do the same with the other
covers (27L) & (27R) on the left-hand
side.
11. FITTING THE HANDLEBAR.-
Bring the handlebar (19) up to the
handlebar stem (91), Fig.13, insert the
hand-grip cable (5) in through the slot
as shown in Fig.13, and pull it out
through the top of the handlebar stem.
Refit the screws (20), the washers
(45) and the spring washers (13), and
tighten securely.
12. FITTING THE FOOTRESTS.-
Position the right footrest (35R marked
with the letter "R") on top of the unit's
right foot (34R), Fig.12, (left and right
refers to the user's position doing
exercise) refit the knob (41), the
washers (40) and the screws (37) and
tighten securely.
Next, position the left footrest (35L
marked with the letter "L") on top of
the left foot (34L), refit the knob (41),
the washers (40) and the screws (37)
and tighten securely.
13. FITTING MONITOR.-
ATTACHING THE FEEDBACK
CABLE.
Take hold of the cable (87), which is
sticking up out of the main post (91),
Fig.13, and plug it into the connector
of the electronic unit (1), as shown in
Fig.13.
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connectors
(5-5A), sticking out of the main post
(91),
and
connectors located at the back of the
monitor (1), as shown in Fig.13.
ATTACHING THE MONITOR.-
Next, slide the front of the monitor (1)
onto the plate on top of the main post
(91) in the direction of the arrow,
Fig.13, push the cables down into the
main post making sure not the pinch
any of the cables. Replace the screws
(2).
Take the left (3L) and right (3R)
covers and position them on the main
post (91), Fig.14. Now use the screws
(4) to attach them to the post.
ATTENTION:
It is important to retighten all of the
screws involved in assembling the
machine after approximately a week of
use as this will prevent any strange
noises and possible damage.
17
plug
them
into
the
