Hansgrohe AXOR Carlton 17725 Serie Instrucciones De Montaje página 7

C L E A N I N G
see enclosed brochure
O P E R A T I O N (see page 64)
F A U L T
⁄ Insufficient water
⁄ Crossflow, hot water being forced into
cold water pipe, or vice versa, when
mixer is closed
⁄ Spout temperature does not corre-
spond with temperature set
⁄ Temperature regulation not possible
⁄ Instantaneous heater didn't work with
thermostat
⁄ Safety stop button not operating
⁄ Diverter stiff
⁄ Diverter leaking
S P E C I A L I N F O R M A T I O N F O R U K
(see page 73)
C A U S E
⁄ Supply pressure inadequate
⁄ Regulator filter dirty
⁄ Shower filter seal dirty
⁄ Backflow preventers dirty or leaking
⁄ Thermostat has not been adjusted
⁄ Hot water temperature too low
⁄ Temperature regulator dirty or calcified ⁄ Clean temperature regulator, ex-
⁄ For new installations: basic body incor-
rectly connected (should be: cold
right, hot left) or installed with 180º
rotation
⁄ Filters are dirty
⁄ check valve hasn't moved back
⁄ Flow limiter in handshower isn't re-
moved
⁄ Spring defective
⁄ Button calcified
⁄ Cartridge defective
⁄ Dirt or sedimentation on valve seat.
A S S E M B L Y (see page 60 )
0 7
T E S T C E R T I F I C A T E (see page 66)
R E M E D Y
⁄ Check water pressure (If a pump has
been installed check to see if the
pump is working).
⁄ Clean filter in front of the mixer and on
the MTC-thermo cartridge
⁄ Clean filter seal between shower and
hose
⁄ Clean backflow preventers, exchange
if necessary
⁄ Adjust thermostat
⁄ Increase hot water temperature to
42 ºC to 65 ºC
change if necessary
⁄ Install function block turned through
180º
⁄ Clean the filter ⁄ exchange filter
⁄ Exchange thermo cartridge
⁄ Remove flow limiter
⁄ Clean spring and ⁄or button, exchange
if necessary
⁄ Exchange cartridge
⁄ Clean valve seat or exchange diverter