Emptying The Bucket; Blowing Feature - Sears Craftsman CMXEVBE176780 Manual De Instrucciones

Emptying the Bucket (Fig. N)
WARNING:
!
To reduce the risk of injury from accidental starting,
unplug power cord before emptying the bucket.
1. Remove the Powerhead Assembly: Pull Powerhead
Assembly Latches outward to release from the Bucket.
2. Lift the Powerhead Assembly up and away from the
Bucket.
3. Lay Powerhead Assembly upside down on a clean area
while emptying the Bucket.
4. Dump the Bucket contents into the proper waste
disposal container.
Fig. N
12
SP7084-1 CMXEVBE176780.indb 12
Blowing Feature (Fig. O)
Your Vac features a Blowing Port. It can blow sawdust and
other debris. Follow the following steps to use your Vac
as a Blower.
1. Locate the Blowing Port on the back of your Powerhead
Assembly.
2. Insert one End of the Hose Assembly into the
Powerhead Assembly Blowing Port. The Hose should
be secure into place.
To remove the Hose from the Powerhead Assembly:
Twist and pull out on the Hose Assembly to release the
Hose from the Powerhead Assembly Blowing Port.
3. (Optional) Attach an Accessory to opposite end of
Hose.
4. Turn Powerhead Assembly ON and you are ready to
use your Vac as a Blower.
WARNING:
!
Always wear safety eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before using as a blower.
Bucket
WARNING:
!
To reduce the risk of injury to bystanders, keep them
clear of blowing debris.
CAUTION:
!
Wear a dust mask if blowing creates dust which might
be inhaled.
CAUTION:
!
To reduce the risk of hearing damage, wear ear
protectors when using the Vac / Blower for extended
time or in a noisy area.
Fig. O
Blowing Port
Hose
8/3/19 7:22 AM