Setting Dip Switches - Westinghouse LD-0003-07/WH/GS/55 Manual De Instrucciones

HOW TO USE THE FAN/LIGHT WITH REMOTE CONTROL

SETTING DIP SWITCHES

When two or more fans are located near each other, you may desire to have the receiver/transmitter for each
fan set to a different code, so that the operation of one fan does not affect the operation of the other fans.
The DIP switches for the receiver are located on the flat surface of the receiver. The DIP switches for the
transmitter are in the battery compartment. Fig. 8.
NOTE: Ensure that the power to the supply wires has been turned off before setting the code.
NOTE: Before you change the DIP switch settings, make sure the battery is not connected to the transmitter.
Receiver DIP switches
Change the position of the DIP switches in the remote transmitter and the receiver. Make sure
that the DIP switches match in the remote receiver and transmitter. If they don't match, the
transmitter will not function. Fig. 9.
GS-78013-WH09
Transmitter DIP switches
Figure 8
Example DIP Switch Settings
Receiver 1
DIP Switches Set
to 0111
Transmitter 1
DIP Switches Set
to 0111
8
Receiver 2
DIP Switches Set
to 0100
Transmitter 2
DIP Switches Set to
0100
Figure 9