Technoflex SILVER STAR F-90 Manual De Instrucciones/Lista De Recambios página 15

1.6 Instructions of Use
- Starting the Engine:
1. Turn the Stop Switch clockwise to the position "ON".
2. Push the security " death man " button to the position "ON"
3. Push the primer button to feed the fuel to the carburetor until overflows from the carburetor.
4. Set the remote control wire at the position 1/3 of the way toward the high-speed position.
5. If the engine is warm or the ambient temperature is high close the choke lever half way or keep it
fully open.
6. If the engine is cold or the ambient temperature is low, close the choke lever.
7. Pull the handle slowly until resistance felt. Return the handle to its original position and pull swiftly.
Never pull out the rope all the way.
8. After starting the engine return the handle to its original position.
- Stopping the Engine:
1. Set the remote control wire at low speed the position and allow the engine to return at low speed
for 2 or 3 minutes before stopping.
2. Turn the Stop Switch counter-clockwise to the position "0FF".
3. Pull the starter handle slowly and return the handle to its original position when resistance felt.
* For more information refer to engine manual.
- Using the Trowel:
Guiding the trowel on the slab is very simple. Get into the operators position behind the center of
handle for obtaining to the desired speed, turn the throttle to right.
For moving the machine on the left, lift the handle up.
For moving the machine on the right, lift the handle down.
When holding the handle in natural position, the machine will remain stationary.
INGLÉS
OPERATION
1B
1B-5