Metabo HPT CJ 90VST2 Manual De Instrucciones página 11

CUTTING
CAUTION
In order to prevent blade dislodging, damage
or excessive wear on the plunger, please make
sure to have surface of the base plate attached
to the work piece while sawing.
1. Rectilinear cutting
When cutting on a straight line, fi rst draw a marking
gauge line and advance the saw along that line.
Using the guide (sold separately) will make it possible
to cut accurately on a straight line.
(1) Loosen the base bolt hexagonal bar wrench attached
on base. (Fig. 12)
Hexagonal bar wrench
Base bolt
Base
(2) Move the base fully forward, and tighten the base bolt
again. (Fig. 12)
(3) Attach the guide by passing it through the attachment
hole on the base and tighten the M5 bolt. (Fig. 13)
M5 bolt
Fig. 12
Attachment hole
Guide
Fig. 13
(4) Set the orbital position to "0".
NOTE
To ensure accurate cutting when using the Guide
(Fig. 14), always set the orbital position to "0".
Change knob
2. Sawing curved lines
When sawing a small circular arc, reduce the feeding
speed of the machine. If the machine is fed too fast, it
could cause the blade to break.
Set the orbital position to "0".
3. Cutting a circle or a circular arc
The guide also will be helpful for circular cutting.
After attaching the guide by same way noted as
above, drive the nail or screw into the material
through the hole on the guide, then use it for a axis
when cutting. (Fig. 15)
Set the orbital position to "0".
Sub base
Guide hole
Guide
English
Guide
Fig. 14
Change knob
Wood screw
or nail
Fig. 15
11