IKAR ACB 1,8 Instrucciones De Uso página 16

GB
3. The required clearance below the edge is shown in Figures
4. In order to prevent a fall with a swinging movement, the working area and the lateral movement from the
centre line should be limited to max. 1.50 m on both sides. In other cases, no single anchor points should
be used, but e.g. type C anchor devices (only if approved for shared use) or type D devices according to EN
795.
5. For use of the fall arrester on a type C anchor device according to EN 795 with a horizontally flexible anchor
line, the excursion of the anchor device should also be considered when determining the required clearance
underneath the person using the device. The information provided in the instructions for use and the safety
information of the anchor devices should be observed in this context.
6. In case of a fall over an edge, there is a danger of injury during the process of arresting the fall due to the
falling person hitting parts of the building or structure.
7. Special measures for rescue should be defined and trained for cases of falls over an edge.
Please note: In order to prevent a negative impact on the safe function of the fall arresting devices, it is only
permitted to use accessories approved by the manufacturer (e.g. rescue clamps to DIN 19428:2018, protective
covers, etc.). The manufacturer is not liable for any accidents involving the life and limb of the user if using non-
approved accessories.
14
Fall over edges at right angle
Safe distance
(minimum)
+
14
Accessories
15
3.00m
Safe distance
+ 1.00m
(minimum)
4.00 m
16
.
15
Fall over edges with lateral offset
13
3.00m
+ 1.00m
4.00 m