Cleaning, Maintenance And Ordering Of Spare Parts - ALPHA-TOOLS FMR 1100 Manual De Instrucciones

Anleitung FMR 1100 SPK7
GB
Working with the paint and mortar
mixer
The additional handle must be fitted!
The mains plug must first be disconnected when you
wish to change the mixer tool.
When you insert the mixer into the product or take it
out of the product, reduce its speed.
Once the mixer is fully immersed in the product,
increase the speed to maximum to ensure that the
motor is cooled adequately. During the mixing
process guide the machine through the mixing
vessel. Continue to mix the product until it is fully
homogenized. When you have finished the mixing
work, clean the mixer.
Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
8
14.08.2006 8:47 Uhr Seite 8
Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info