Replacing The Power Cable; Carbon Brushes; Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - ALPHA-TOOLS FMR 1100 Manual De Instrucciones

Anleitung FMR_1100_SPK7:_
6.5 Working with the paint and mortar mixing
tool
The additional handle must be fitted!
Before changing the mixing tool you must pull the
power plug.
Reduce the working speed when you immerse the
mixing tool into the material you want to mix and
when you take it out again. When the mixing tool is
fully immersed, raise the speed to maximum in order
to ensure adequate cooling of the motor. Move the
mixing tool through the mixing container during the
mixing operation. Continue mixing until all the
material has been thoroughly processed. When you
are finished with your mixing work, clean the mixing
tool.
6.6 Using the equipment as a drill
First fit a suitable drill in the tool.
Connect the mains plug to a suitable socket.
Position the equipment in the position you wish to
drill.
Switch on the equipment as described under
"Starting up".

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
24.06.2008 9:04 Uhr Seite 11

8.2 Carbon brushes

In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
11