Connect An Rs-232 Serial Cable (Optional); Connect An Rj-45 Lan Cable; Connect The I/O Module Cable (Optional) - Cognex In-Sight CIO-MICRO Manual De Instrucciones

Note: The CC-Link network is daisy-chained and requires a terminal
resistor for the first and last devices in the chain. Make certain that your
connections are correct. Refer to the CC-Link website for more
information and specification details.
5. Tighten the screw terminals with the screwdriver to secure the wire leads in
the terminal block; the maximum torque is 0.1921 Nm (1.7 in-lb).

Connect an RS-232 Serial Cable (Optional)

To connect the vision system to a serial device, plug an RS-232 serial cable (DB9
connector) into the I/O module's RS-232 port and connect the other end of the cable
to the serial device. Tighten the connector screws to secure it to the I/O module.

Connect an RJ-45 LAN Cable

To connect the vision system to an Ethernet network, plug a LAN cable (RJ-45
connector) into the I/O module's LAN port and connect the other end of the cable to a
switch/router or PC, as applicable.

Connect the I/O Module Cable (Optional)

The I/O module's I/O port supplies connections for the In-Sight Micro vision system's
acquisition trigger and high-speed outputs.
CAUTION: All cable connectors are "keyed" to fit the connectors on the vision
system; do not force the connections or damage may occur.
1. Connect the I/O Module cable's M8 connector to the vision system's I/O
connector.
10