Dometic FlyTec FT100 Instrucciones De Montaje página 21

Dometic FlyTec FT100
5.4 Installing the flyscreen
A
NOTICE!
 Choose suitable plugs and screws depending on the floor and
roof construction.
 Make sure that you do not drill through the floor and roof.
Securing the skirting board and upper guide rail
➤ Align the position of the cassette profile perpendicular to the skirting board
and the upper guide rail.
➤ Secure the skirting board to the bottom plate (fig. 4, page 4) with four
countersunk screws (Ø 4 mm).
➤ Secure the upper guide rail to the vehicle (fig. 5, page 5) with four coun-
tersunk screws (Ø 4 mm).
Installing the cover on the B pillar (fig. 6, page 5)
A
NOTICE!
 Depending on the type of vehicle, the spacers behind the cov-
er must be adapted to the correct length.
 The contour of the cover may need to be adapted to the interior
fittings in the upper and lower area.
 It may also be necessary to adapt the interior fittings.
➤ Put the cover on the B pillar so that it is flush on all sides.
➤ Align the cover on the bottom of the skirting board and mark the drill holes.
➤ Pre-drill at the marked points if the wall construction requires this.
➤ Secure the cover on the wall with five countersunk screws (Ø 4 mm).
Installing the magnetic plate (fig. 6, page 5)
A
NOTICE!
 The adhesion points must be clean, dry and free of grease in
order for the magnetic plate to adhere well to the cover profile.
 Clean the adhesive surface with a suitable cleaner. It may be
necessary to check suitability on a hidden spot.
 Use lint-free cloths.
➤ Glue on the magnetic plate.
EN
Installing the flyscreen
21