Battery Charging - Protector PHANTOM Instrucciones De Funcionamiento

Replace the filter cap on the used filter,
remove and dispose
accordance with any plant or safety
authority instructions.
Gently push the blower assembly out of
the facemask and feed the cable through
the mask opening.
Facemask:
CAUTION:
Wash the facemask in a tepid soap and
water solution. Use toilet soap, not
detergent. Rinse thoroughly in clean
running water,
attention to the exhalation valve.
After rinsing, shake the mask vigorously
to remove excess water and allow to dry
away from direct heat or sunlight. To
avoid damage to the visor, do not place
the mask face down on rough surfaces.
CAUTION:
Dry the respirator thoroughly if it is to
be stored at temperatures
freezing.
Note:
Where disinfection
rinsing, use TriGene
facemask thoroughly in clean water.
When dry, polish the visor inside and out
with a clean lint-free soft cloth. Replace
the visorguard for protection.
Inspect individual parts of the facemask
and replace missing or damaged parts.
Fully slacken the head harness ready for
use.
Blower:
CAUTION:
DO NOT immerse
assembly.
Note:
The blower is a sealed unit and cannot be
serviced beyond O-Ring and filter seal
replacement.
Wipe the blower with a damp cloth or
disinfectant wipe.
Inspect the O-Ring and filter seal and
replace if damaged.
of safely in
paying particular
below
is required after
solution. Rinse the
TM
the blower
Battery:
CAUTION:
DO NOT
assembly.
The battery may be wiped with a damp
cloth.
Note:
The battery is a sealed unit and cannot
be serviced.
MAINTENANCE
Maintenance
performed by trained personnel. Please
contact Scott Health and Safety Limited
for training information.

Battery Charging:

WARNING:
Batteries MUST be charged in a safe
area.
Optimum performance with new battery
packs is achieved only after they have
completed three
maintain the optimum performance Scott
Health and Safety Limited recommend
that the battery pack is fully discharged
approximately once every fifty uses.
Plug the battery charger into a suitable
mains supply. Plug the charging lead into
the battery socket and turn fully clockwise
to the ON position.
During charging, the battery LED is lit
continuously
connection between the charger and
battery has been made.
The red LED on the charger will illuminate
and remain illuminated throughout the
charging period. If a SmartCharger is
used, the LED will flash slowly once the
battery is fully charged.
If the standard battery charger is used,
the battery should reach a full charge in
approximately 16 hours. Use of the
optional SmartCharger
charging time to around 7 hours and
removes the need for a periodic complete
discharge cycle.
5
PHANTOM
immerse the battery
tasks must only
charge-cycles.
indicating that a
reduces
be
To
good
the