Telcoma Automations TANGOOC2 Manual De Uso página 30

GB
HOW TO DELETE CODES
1. How to delete a code.
With this operation one or more codes may be deleted from the receiver
memory.
- During the programming stage, press the P button 4 times.
- The LED corresponding to the button will emit 5 series of 4 blinks.
- During this stage transmit using the remote control that has to be deleted.
The LED will light up steadily for a few seconds indicating that the delete
procedure has been successfully completed.
2. How to delete all codes (reset)
If the device is reset, the receiver memory is deleted entirely.
- Keep the P1 button in fig.1 pressed for at least 10 seconds until the
LEDs of both buttons light up simultaneously. After a few seconds the
LEDs will go off, indicating that the delete procedure has been succes-
sfully completed.
- Repeat the learning procedure.
WHAT THE LED BLINKS MEAN
(LED1 and LED2 in fig.1)
- LED2 lit up for 3 seconds: power has just been supplied to the receiver.
- An LED blinks shortly once: transmission has occurred with a correctly
memorized remote control and the corresponding output activates.
- All LEDs blink simultaneously: during the programming stage this means
that a transmitter which has already been enabled is being memorized.
- The LEDs blink alternately: during the programming stage this means
that the memory is full.
30