Telcoma Automations TANGOOC2 Manual De Uso página 28

GB
memorized (fig.1, button P1).
The LED next to the button will blink 5 times.
- While the LED is blinking, press the button on the transmitter corre-
sponding to the code to be memorized.
A longer blink of the LED on the receiver will acknowledge correct memorization.
Repeat the operation to perform self-learning of any other transmitters.
During the programming procedure the distance between the transmit-
ter and the receiver must be about 50cm.
2- Remote self-learning (FOR THE FM400 SERIES ONLY)
The FM 400 series gives the possibility of memorizing remote controls di-
rectly in the receiver without having to manually operate it as described
in the previous chapter.
To do so it is necessary to have at least a functioning remote control
which has already been memorized (A in fig.4) in the receiver using the
procedure described above.
All the stages of the programming procedure are displayed in Fig. 4.
The operations described below must be carried out observing the times specified.
Referring to fig.4:
1 – Remove the front panel on the transmitter which has already been
memorized on the receiver (A), there is a hole in the centre of the remote
control (C5).
Stand a few meters away from the receiver and:
2 – Using a pointed tool (e.g. a pen), press the C5 button, which is located
inside the hole, for at least 3 seconds.
3 – Release the C5 button and within 2 seconds press shortly, on the
same remote control (A), the button which is already memorized in the
receiver (example: C1)
4 – Within 2 seconds press the button on the remote control (B) which
has to be memorized in the receiver.
28