VOX electronics EM-2100 Manual De Usuario página 9

4. Fill the water reservoir with drinking water.
NOTE: Do not fill above the MAX water level mark.
5. Replace the ice basket and close the top lid.
6. Press "ON/OFF" key and the "ICE" indicator lights solidly.
7. The ice-making cycle will last approximately 7-15 minutes, depending on the ambient
temperature and water temperature.
8. The ice-making cycle starts with water being pumped into the ice tray situated below the
evaporator. Over the next 7-15 minutes ice is formed on the evaporator. Once this has
completed, the ice tray will tilt backwards and the remaining water in the ice tray is drained
back into the water reservoir. The ice cubes are then dropped from the evaporator and
pushed forward into the ice basket by the ice shovel. The ice tray will automatically move
back into position under the evaporator and start the next cycle.
9. The "ICE FULL" indicator will light up when the ice basket is full and then the ice maker
will stop the ice-making cycle automatically. Gently remove the ice from the ice basket with
the ice scoop. About 7.5seconds later, the ice maker will restart its ice making function
automatically.
10. The "ADD WATER" indicator will light up when the water reservoir lacks water and the
ice-making cycle will stop automatically. If so, remove the ice basket and add water to the
water reservoir and then press "ON/OFF" key again to restart the ice-making cycle. The
appliance will start working automatically after about 20 minutes if the operator forgets to
restart the appliance after refilling it.
11. When you get your desired amount of ice, stop the ice making cycle by pressing the
"ON/OFF" key and unplug the unit from the wall outlet.
12. Open the top lid and transfer the ice to a freezer.
13. Allow the ice maker to reach room temperature.
14. Suggest replacing the water every week. Please empty the water reservoir if the ice
maker is not used for a long time.
7