Electronic Circuit Board - Euronda EUROSEAL 2001 PLUS Manual De Instrucciones

EUROSEAL ® 2001 PLUS
SILICON RUBBER BAND:
Disassemble the unit - G - as described above and remove the silicone rubber - N -. Insert
the new rubber by pressing it in.

ELECTRONIC CIRCUIT BOARD:

Lower the lever and unscrew the grip of pin - C -, remove the front carter - R - taking away
the screws - O - acting with the screwdriver into the hole - V -. Remove also the two pins - P -
under the machine.
Take away the screws - T - and the circuit card.
Once replaced the defective parts, reassemble the machine following the
inverted order.
REPLACING
OF THE CUTTING EDGE:
Remove the screw - A -, from
one of the two sides - B - of the
higher carrier - C - that simply
slips off from the cuttinghandle
- E -. Being careful not to cut
yourself, slip off from the cutting
bar - D -, the handle - E - and
remove the two screws - F - and
you can replace the blade - G -.
Once the substitution is com-
plete reassemble the machine
in the reverse order.
14