Special Information - Electrolux EYE030S1WE Manual De Instrucciones

4 www.electrolux.com
Never remove or damage stickers, warning labels or
•
nameplates attached to the appliance.
A qualified technician carrying out the installation is
•
obliged to observe applicable national standards and
regulations concerning connection to the water
distribution system and the electric network. The
manufacturer is not responsible for any unprofessional
or incorrect installation.
Check that the specifications written on the
•
appliance's identification plate are the same as those
of the electrical power supply.
This appliance is manufactured and tested in
•
accordance with valid regulations.
To prevent scalds, While using the water heater,
•
always check the water temperature and adjust as
needed before use.

1.3 Special Information

This appliance is intended to be used to store, heat
•
and provide drinking water and has no negative
impact on inlet water.
The power cable may only be replaced (for example if
•
damaged) by a qualified contractor authorised by the
manufacturer, using an original spare part.
The electrical installation must have an isolation
•
device which lets you disconnect the appliance from
the mains at all poles. The isolation device must have
a contact opening width of minimum 3 mm.
Before any work on the appliance, disconnect all poles
•
of the appliance from the power supply.
The water heater must be installed with the safety
•
valve, which has a non return valve (supplied with the
water heater).
No hydraulic accessory needed to be installed
•
between the safety unit and the cold water inlet tube
service valve (plug valve, non-return valve, etc).