FITFIU FITNESS MC-600 Manual Usuario página 68

TROUBLESHOOTING
The following information may assist in identifying a problem and rectifying it.
Problem
The wire from computer to bottom
E01
control board didn't connected well
E02 Protect the exploding
E05 Over current Protection
E06 Motor wire not connect well
E08 EEPROM damage
STORING AND TRANSPORT
A
B
Cause
A
B
68
Solution
1. Check the connection wire between computer and
control board was well connected.
2. Make sure the IC on the control board was well
inserted. If not re-insert.
1. Check if the power voltage is 50% lower normal
voltage, please use the correct power voltage to test
again.
2. Check if the control board is burnt out, change a
good control board.
3. Check if the wire is well connnected with motor,
reconnect well.
1. Overloaded.
2. Running board with heavy resistance, need to be oiled
3. Damage in Motor. Change a new motor.
Check if the motor wire is connect well, if not,
reconnect the wire well. Check if the control
board is burnt out, if yes, change a good
control board.
Change the control board
FOLDING
Pull up the base frame at position A, till
hearing the sound that the air pressure
bar B is locked into the round tube.
UNFOLDING
Support place A with hand , kick the
place of air pressure bar, then the
base frame will fall down automatically
(Please keep anybody and any pet
away the machine when falling down).