Location And Installation - Nordcap ABS Serie Manual De Instrucciones

Location and Installation

The cabinet should be placed in a room that is dry and sufficiently ventilated. To operate
efficiently it should not be positioned in direct sunlight or near warm appliances. Please
note that optimal cabinet performance is obtained at an ambient temperature between
+16 °C and +35 °C.
Freezer, Refrigerator: By placing the cabinet in an environment with high air humidity, it may be
necessary to acquire extra equipment for evaporation of the drip water in the pan near the
compressor.
The cabinet can be installed freestanding against a wall.
Important
The cabinet must have sufficient ventilation and free air circulation beneath, above and behind the
cabinet. The legs under the cabinet will help ensure sufficient air space.

Remove the appliance from the packaging. Make sure that all protective plastic film and coatings
are thoroughly removed from all surfaces. To prevent injury or damage to the unit, we
recommend that the appliance should be unpacked and set up by two people.

The appliance should be placed on a solid level floor to reduce noise and vibration. Level the
appliance by adjusting the screw feet.

Check that the power supply and voltage used comply with the details on the rating plate. The
plug must be accessible after installation

Correctly connect and disconnect the plug. When inserting ensure the plug is fully engaged.
When unplugging do so by holding the body of the plug. Never pull the supply cord directly.

If the appliance is to be shut down for long period, switch it off and disconnect the plug from
socket outlet. Clean the appliance and leave the door open to prevent odour.

Important! For your personal safety, this appliance must be properly grounded (earthed). This
appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must
be insert ed into an outlet that is properly grounded and installed. Consult a qualified electrician
or service center if you do not completely understand the grounding instructions. If doubt exists
whether the appliance is properly grounded, have a qualified electrician check the circuit to
make sure the outlet is properly grounded.

If the cable does not reach the nearest socket, either rearrange your store layout or ask a
qualified electrician to fix a ne w socket.

If power is cut off, wait for at least 3 minutes before restarting the appliance to avoid damaging
the compressor.
Note: If the unit has not been stored or moved in an upright position, let it stand upright for
approximately 12 hours before operation.
Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.
P2M031STD - Ver.1.0 7 GB