Idiomas disponibles
Idiomas disponibles
Safety
Im portant Safety
Instructions
SAVE THESE INSTRUCTIONS - This manual
contains important instructions that should be
followed during installation, operation, and
maintenance of the product. Save this manual
for future reference.
This is the safety alert symbol. When you
see this symbol on your equipment or in this
manual, look for one of the following signal
words and be alert to the potential for personal
injury!
indicates a hazard which, if not
avoided, will result in death or serious injury.
indicates a hazard which, if not
avoided, could result in death or serious injury.
indicates a hazard which,
if not avoided, could result in minor or
moderate injury.
NOTICE addresses practices not related to
personal injury.
Carefully read and follow all safety instructions
in this manual and on tank and pump.
Keep safety labels in good condition. Replace
missing or damaged safety labels.
Risk of explosion. To prevent
possible serious or fatal injury and/or damage
to equipment, system pressure must be less than
75 pounds per square inch (PSI) (517kPa) under
any circumstances. Failure to follow instruction
can result in tank blowup. If system discharge
pressure can exceed 75 PSI (517kPa), install a
relief valve capable of passing the full pump
volume at 75 PSI (517kPa).
Risk of freezing. Do not allow
pump, tank, or piping system to freeze. Freezing
can severely damage equipment and may lead
to tank explosion and serious injury. Allowing
tank to freeze voids tank warranty.
NOTICE Support the piping to and from the tank
to prevent damage to the bottom tank fitting.
1. Test well water for purity before using it.
2. Disconnect power to pump and re lease
all pressure in system be fore installing or
servicing tank.
3. Follow local codes when installing tank.
4. Drain all water from system before performing
any maintenance on tank.
2
