Temperature Sensors - Eldes EW2 Manual De Instrucciones

2. CONFIGURING AND PAIRING WITH THE SYSTEM
ELDES
Configuration Tool
3. EW2 ZONES, PGM OUTPUTS AND TAMPER
Upon successful EW2 pairing process, the system adds 4 wireless Instant-type zones intend-
ed for sensor connection and 2 wireless PGM outputs intended for electrical appliance, relay
or siren connection. In case of tamper violation, the alarm is caused regardless of system be-
ing armed or disarmed.
The wireless connection loss between EW2 and ELDES alarm system leads to alarm. The
system identifies this event as a tamper violation and sends alarm by SMS text message and
phone call to the listed user (-s) by default. The SMS text message contains the wireless de-
vice model, wireless ID code and tamper name.
The tamper will not operate if the wireless zones are disabled.
The response time might be delayed, while controlling the PGM outputs on a
battery-powered EW2.
For more details on EW2 configuration, please refer to ELDES Configuration Tool software's
HELP section.

4. TEMPERATURE SENSORS

EW2 supports up to 2 temperature sensors of 10kΩ NTC or PT1000 type. You may use a
single temperature sensor or multiple temperature sensors simultaneously. Multiple temper-
ature sensors must be of the same type each connected to its own T1/T2 terminal. Once the
temperature sensor (-s) is wired, it is necessary to select the corresponding type using ELDES
Configuration Tool software after pairing EW2 device with the system.
8 EN
For more details on how to configure and pair the device with the
system, please refer to ELDES Configuration Tool software's HELP
section or ELDES alarm system's installation/user manual.
If you are unable to pair the wireless device, please restore the
parameters of the wireless device to default and try again (see
6. RESTORING DEFAULT PARAMETERS for more details.)
WIRELESS ZONE AND PGM OUTPUT EXPANSION MODULE EW2