Troubleshooting - Kompernaß KH 1150 Instrucciones De Uso

11 Troubleshooting

Problem/Fault
The fastening screws cannot be screwed
tightly or were turned too far during instal-
lation
The fan does not start
Fan runs loudly or sways significantly
Light does not function
Do not perform any modifications or repairs on the product!
Safety-relevant parts may only be repaired by a specialist.
Possible Cause(s)
Building fuse or circuit breaker defective
The direction switch is positioned in the
middle
Set the pull chain switch to the "OFF" setting
Loose cable plug
Fan defective
Blade mounts not firmly connected
Blade damaged
Blade not balanced out
Loosen blade attachment(s)
Fan is not hung correctly
Bulb defective
Loose cable plug
- 23 -
Remedy
Replace the screws and nuts Only use
screws that match the original screws;
contact the manufacturer or retailer for
information.
Check the building fuse or circuit breaker
and replace if necessary
Set the direction switch to the up or down
position
Pull the pull chain once
DANGER :
Disconnect the fan from the mains network
before checking the cable plug. Check the
cable plug
Have the ventilator checked by specialists
or send it to Customer Services (Address -
see Chapter "Warranty and Service")
Check the screw connection of the blade
mounts
Check the blades, replace if necessary
Change the positionings of the blades
amongst themselves
Check the blade attachments
DANGER :
Disconnect the fan from the mains network
before checking whether it is hung correctly.
Check the fastening of the installation plate
and extension rod, and correct any improper
fastening.
Check the halogen bulbs and replace
defective bulbs
DANGER :
Disconnect the fan from the mains network
before checking the cable plug. Check the
cable plug