Circuit Diagram - Nordcap CR 90 Serie Manual De Instrucciones

TECHNICAL DATA
CAUTION: RISK OF FIRE AND EXPLOSION WITH FLAMMABLE REFRIGERANT R600a
Environmental Protection
Discarded electric appliances are recyclable and should not be discarded in the domestic waste! Please actively
support us in conserving resources and protecting the environment by returning this appliance to the collection
centres (if available).
GB

CIRCUIT DIAGRAM

P1 POWER PLUG
S1 MAIN SWITCH
TH1 THERMOSTAT
C1 COMPRESSOR
QF1 OVERLOAD
R1 RELAY
F1 CONDENSER FAN
F2 EVAPORATOR FAN
F3 EVAPORATOR FAN
SQ1 TEMPERATURE PROBE
FC1 FAST CONNECTOR
FC2 FAST CONNECTOR
TROUBLESHOOTING
If your appliance develops a fault, please check the following table.
Fault
The appliance is not working
The appliance turns on, but the
temperature is too high/ low
The appliance is unusually loud
The appliance is leaking water
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Too much ice on the evaporator
Condenser blocked with dust
Doors are not shut properly
Appliance is located near a heat source or air
fl ow to the condenser is being interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being stored in
the appliance
Appliance is overloaded
Loose nut/ screw
The appliance has not been installed in a
level or stable position
The appliance is not properly leveled
The discharge outlet is blocked
Movement of water to the drain is obstructed Clear the fl oor of the appliance (if applicable)
The water container is damaged
The drip tray is overfl owing
13
.
FC1 FC2
FC1 FC2
3
Action
Check the unit is plugged in correctly and
switched on
Call your agent or qualifi ed technician
Replace the fuse (UK Plug)
Check power supply
Defrost the appliance
Call your agent or qualifi ed technician
Check doors are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any excessive hot foodstuffs or
blockages to the fan
Reduce the amount of food stored in the
appliance
Check and tighten all nuts and screws
Check installation position and change if
necessary
Adjust the screw feet to level the appliance
(if applicable)
Clear the discharge outlet
Call your agent or qualifi ed Technician
Empty the drip tray (if applicable)