Tabla de contenido
Idiomas disponibles
Idiomas disponibles
BATTERY BACKUP
The clock, alarm and preset stations settings can be protected against AC power
failure with the batteries for a short period of time. If no backup batteries are
installed or the power failure is prolonged, you will need to set the clock again.
STANDBY MODE
Place the unit on a flat stable surface and plug the power cord into the mains
socket.
The unit is in standby mode and "0:00" will flash on the display.
SETTING THE CLOCK
1.
In standby mode, press and hold SET until the display flashes.
2.
Whilst the display is flashing, repeatedly press HR and MIN respectively
until the desired clock time appears.
Press and hold HR and MIN respectively for fast advance.
3.
Press SET to confirm.
The hour and minute digits will stop flashing.
POWER ON/RADIO MODE
Press POWER to switch the unit on and enters the radio mode.
The radio frequency will briefly appear on the display and then return to
clock time.
RADIO OPERATION
1.
Press POWER to turn on the radio.
The default FM frequency or the last frequency
you tune the radio to.
The default FM radio frequency is 87.5 MHz.
2.
Press BAND once to enter the AM radio mode.
The default AM radio frequency is 522 kHz.
3.
Repeatedly press BAND to select the desired radio band.
4.
Adjust the volume by repeatedly pressing VOLUME
5.
Repeatedly press TUNING
Press and hold TUNING
release the button, the unit will scan the frequencies until a
broadcasting station strong enough for good reception is found.
EN
/
/
to tune into the desired station.
/
for about 2 seconds and then
3
.
Tabla de contenido
