Data Table; Scope Of Supply - Wilo IPL Manual De Instrucciones

English

5.2 Data table

Approved fluids
Permissible fluid temerature range
max. ambient temperature
max. working pressure
Installation method
Construction materials pump housing Cast iron
Impeller
Stub shaft
Pipe and gauge connections
Mains power supply
Degree of motor protection
Special design motor
Legend:
●Standard supply
¹) Allow for hydraulic corrections for glycol. Only approved makes of additives with corrosion inhibi-
tors must be used. Observe manufacturers´instructions. Contact WILO before using other than
above listed fluids other ratio of mixtures and higher temperatures.
²) On- site trip unit required
When ordering spare parts, all data of pump and motor name plate must be
stated.

5.3 Scope of supply

• Pump complete
• For pumps with flanges up to 2": flange gaskets
• Installation and maintenance instructions.
5.4 Accessories
Companion Flange Sets must be ordered separately. Please contact your local
WILO distributor.
8
Heating water
Chilled/ Cold water
Water/glycol mixtures ¹)
Heat transfer oil
Other fluids on request
from 15 °F to 250 °F [-10°C to +120°C]
104 °F [40 °C]
145 psi [10 bar ]
Inline
Fibre reinforced plastic (polypropylene or
noryl)
Stainless steel AISI 420
Flanges acc. ASME Class 125
Flange with tappings 1/4" NPT
1
115 / 208 - 230 V, 60 Hz (≤ 2 HP)
~
3 208 - 230 / 460V, 60 Hz (≥ 1 HP)
~
3 575V, 60 Hz (≥ 1 HP)
~
ODP
TEFC
Integrated protection PTC / PTO ²)
Special voltage/frequency
❍Special design or accessories (at added cost on request)
●
●
●
❍
❍
●
●
●
●
●
●
●
●
●
●
●
●
●
❍
❍
❍
Wilo AG 06/2005