• Smaller material plates which do not fill out the heating element,
must be placed on the right-hand side of the heating element where
the temperature sensor is located.
• The four star knobs can adjust the height of the cover based on the
thickness of material being used. The knobs should be screwed in
or out the same amount.
• Maximum pressure--or no pressure at all--can be exerted on the
hold-down clamp by adjusting the star knobs (see picture).
• The sheet material to be processed must be clean and with no re-
sidues, including, for example, coloring pens. It must be processed
without talcum powder.
• For more detailed information on the "optimum processing tem-
perature" and further information on processing the plate material,
see "Manufacturer's Instructions."
• If the maximum pressure is exerted on the material, the surface that
is in contact with the cover may leave an imprint of the Teflon Shee-
ting on the sheet material. This matted surface can be turned either
inside or, for visual effect, to the outside.
7 Control Panel
Signal Lamp Green
Main Switch
„On"
Main Switch
On/off
8 Technical Data
Heating Surface
Temperature Control
Power requirement
(three-phase current)
Width
Depth
Height (with cover opened)
Weight net/gross
Color
Electrical Fittings:
thermostat, safety limiter, heating element, digital timer,
2,5 m connection cable, CEE plug 5x16A und CEE contact 5 x 16 A
or US plug.
14 | Ottobock
759H4=1, 759H4=1USA, 759H4=1USA-SP
max. 860 x 1110 mm
max. 250
C
0
3 x 400V/N/PE, 50-60 Hz, 4,35 KW (759H4=1)
3 x 208V/PE,
50-60 Hz, 4,35 KW (759H4=1USA)
1 x 208V/PE,
50-60 Hz. 4,35 KW (759H4=1USA-SP)
ca. 1137 mm
ca. 887 mm
ca. 1530 mm
115/185 kg
silver-gray, hammer tone finish
Timer, removable
Signal Lamp Red
Heating „On"
Thermostat
Setting the desired
temperature using the
temperature control dia
759H4=2, 759H4=2USA
max. 1000 x 1300 mm
max. 250 °C
3 x 400V/N/PE, 50-60 Hz, 6
KW (759H4=2)
3 x 208V/PE, 50-60 Hz, 6 kW
(759H4=2USA)
ca. 1337 mm
ca. 1037 mm
ca. 1600 mm
127/197 kg
759H4