Stihl MSA 160 C Manual De Instrucciones página 22

English
2
4
Avoid repositioning the saw more than
necessary. When repositioning for the
next cut, keep the guide bar fully
engaged in the kerf to keep the felling
cut straight. If the saw begins to pinch,
insert a wedge to open the cut. On the
last cut, do not cut the hinge.
Plunge-cut Method
Timber having a diameter more than
twice the length of the guide bar requires
the use of the plunge-cut method before
making the felling cut.
First, cut a large, wide felling notch.
Make a plunge cut in the center of the
notch.
20
The plunge cut is made with the guide
bar nose. Begin the plunge cut by
applying the lower portion of the guide
bar nose to the tree at an angle. Cut until
the depth of the kerf is about the same
as the width of the guide bar. Next, align
the saw in the direction in which the
recess is to be cut.
With the saw at full speed, insert the
guide bar in the trunk.
Enlarge the plunge cut as shown in the
illustration.
Warning!
There is an extreme danger of kick-
back at this point. Extra caution must
be taken to maintain control of the
saw. To make the felling cut, follow
the sectioning method described
previously.
If you are inexperienced with a chain
saw, plunge-cutting should not be
attempted. Seek the help of a
professional.
Warning!
In order to reduce the risk of personal
injury, never stand directly behind the
tree when it is about to fall, since part of
the trunk may split and come back
toward the operator (barber-chairing),
or the tree may jump backwards off the
stump. Always keep to the side of the
falling tree. When the tree starts to fall,
withdraw the bar, switch off the motor
and walk away on the preplanned
escape path. Watch out for falling limbs.
Warning!
Be extremely careful with partially fallen
trees which are poorly supported. When
the tree hangs or for some other reason
does not fall completely, set the saw
aside and pull the tree down with a
cable winch, block and tackle or tractor.
If you try to cut it down with your saw,
you may be injured.
Limbing
Limbing is removing the branches from a
fallen tree.
Warning!
There is an extreme danger of kickback
during the limbing operation. Do not
work with the nose of the bar. Be
extremely cautious and avoid contact-
ing the log or other limbs with the nose
of the guide bar.
MSA 160 C