Resistance Measurement - LaserLiner MultiMeter-Home Manual De Instrucciones

6
BAT. Battery charge status measurement
To measure the battery charge status, set the rotary switch to
the "BAT." position with the corresponding measuring range.
1.5 V round cells / AA, AAA, C, D
9.0 V flat cells / E-block
Then connect the measuring contacts
to the battery.
3-colour display scale (D):
Colour Battery charge status
green Good: battery
fully charged
orange Weak: battery is weak
and will soon need
replacing
red Replace: battery
is flat and should
be replaced
7

Resistance measurement

To measure resistance, set the rotary switch to the "Ω" position
with the corresponding measuring range (X10Ω - X1kΩ).
Before each measurement, check that the pointer is set exactly
to „0" on the OHM-scale (A). Hold the two test prods so that they
touch and, if necessary, adjust the pointer with rotary knob (3).
Then connect the measuring contacts
to the object to be tested.
Reading the scale (A):
Measuring
Scale
range
X10Ω 0 Ω - 1 kΩ
X1kΩ 0 Ω - 1 kΩ
MultiMeter-Home
Result
x 10
x 1000
black red
17
EN