1
Switch on the appliance
2
Fill the detergent
dispenser
3
Check the rinse aid level
4
Check the regeneration
salt level
5
Load the baskets
6
Select a programme
7
Running the dishwasher
8
Switch off the appliance
9
Turn off the water tap,
unload the baskets
Quick Operation Guide
Press the Power switch button to switch on the appliance, Open the door.
Big Compartment (A): with each wash cycle.
Small Compartment (B): for programmes with prewash
only.
Check the rinse aid level panel (C) if provided.
If there is no salt warning light in the control panel (for some models), you can esti-
mate when to fill the salt into the softener by the number of cycles the dishwasher
has run.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Close the door. Press the programme button until the selected programme lights up.
( See the section entitled Operation instruction )
Turn on the water tap and press the Start/Pause button. The machine will start working
after about 10 seconds.
Changing the programme:
A running cycle can only be modified if it has been running for a short time. Other-
wise the detergent may have already been released. In this case, the detergent
dispenser must be refilled. dispenser must be refilled. Open the door slightly ,then
press the program button more than 3 seconds to cancel the running programme.
Select a new programme. Close the door, restart the dishwasher.
Add forgotten dishes:
Open the door slightly, You can open the door completely until the spray arms stop.
Add the forgotten dishes. Close the door, the dishwasher will start running again after
10 seconds.
If the appliance is switched off during a wash cycle:
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
dishwasher will sound 8 times, then stop. Turn off the appliance using the Power but-
ton. Since the appliance is standing by, it will power off automaticly after 30 minutes
without any operation.
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to
avoid handling the dishes and utensils while they are still hot and more susceptible to
break. They will also dry better.Unload the appliance, starting from the lower basket.
34