Schumacher Electric SI1000 Manual Del Usuario página 5

CONNECTING THE CONVERTER
CABLE TO A 12V BATTERY OR
12V POWER SOURCE:
1. Keep hands, hair, clothing and jewelry
clear of battery terminals.
2. Wear eye protection and protective
clothing.
3. For a negative-grounded vehicle
(do not use with positive ground
electrical systems), connect the
POSITIVE (RED) ring terminal from the
converter to the POSITIVE (POS, P, +)
ungrounded post of the battery. Connect
8. BATTERY BANK INSTRUCTIONS
BATTERY BANK ASSEMBLY
WARNING: Read these safety
instructions before assembling the
battery bank.
• Connect batteries ONLY in parallel
(negative terminals together to one
cable; positive terminals together
to the other cable), as shown in the
Battery Bank Example.
• Do not connect 12V batteries in a
series with the negative of one battery
connected to the positive of the next.
DANGER: CONNECTING INCORRECTLY
MAY RESULT IN VOLTAGE HIGH
ENOUGH TO CAUSE ELECTROCUTION.
• While assembling the battery bank, wear
splash-resistant ANSI-approved safety
goggles and electrically insulated gloves.
• Connect ONLY similar batteries together
in a battery bank. Do not connect old
to new, flooded to gel cells, or batteries
with different capacities.
• Use extension cables with the specified
gauge (or thicker).
6' or less: 6 AWG; 6-10': 4 AWG
WARNING:
RISK OF EXPLOSIVE GASES.
• Assemble the battery bank in a clean,
well-ventilated location, away from
ignition sources and flammable materials.
• To reduce risk of battery explosion,
follow these instructions and those
published by the battery manufacturer and
manufacturer of any equipment you intend
to use in vicinity of a battery. Review
cautionary markings on these products.
CONNECTING THE BATTERIES
IN PARALLEL
1. First, connect all of the positive
terminals to each other.
2. Next, connect all of the negative
terminals to each other.
3. Connect the negative and positive
output cables to opposite ends of
the bank. Do not allow the output
cables to touch one another.
the NEGATIVE (BLACK) ring terminal
to the vehicle chassis or engine block
away from the battery. Do not connect
the terminal to the carburetor, fuel lines
or sheet-metal body parts. Connect to a
heavy gauge metal part of the frame or
engine block.
4. To disconnect the converter, remove
first the negative terminal and then the
positive terminal.
IMPORTANT: Failure to make the correct
connections will result in blown fuses and
permanent damage to the converter.
4. Test the voltages at the output cables,
to make sure that the battery bank is
correctly wired.
5. If the voltage is higher than 13 volts,
part of the battery bank is probably
connected in series (a negative
terminal of one battery attached to
a positive terminal of another) instead
of in parallel.
6. Carefully examine the diagram and
correct the wiring before attaching to
the converter.
7. Make sure the converter's switch is
set to OFF (O).
8. Connect the output cables from the
battery bank to the converter.
12V/400 Ah
OUTPUT
to NEGATIVE
converter
terminal
†Bank Capacity =
(single battery capacity) x (# of batteries)
400 Ah capacity is for (2) 200 Ah batteries.
*200 Ah batteries shown for illustration
purposes.
• 5 •
Example:
BATTERY BANK
†
12V
-
+
lead-acid
battery
200 Ah*
Connect additional
- 12V 200 Ah*
+
lead-acid
batteries here
to increase capacity
12V
-
+
lead-acid
battery
200 Ah*
OUTPUT
to POSITIVE
converter
terminal