Ribitech IW1200 Manual De Instrucciones Y Mantenimiento página 12

21. Warning
The use of any accessory or attachment, other than those recommended in this instruction
manual, may present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
22. Have your tool repaired by a qualified person
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part
in an authorised service centre is recommended.
This electric tool is in accordance with the relevant safety requirements. Repairs should only
be carried out by qualified persons using original spare parts, otherwise this may result in
considerable danger to the user.
23. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product
especially for any matters that are not referred in the above
SPECIAL WARNINGS WHEN USING THE PRODUCT
1. Become familiar with the controls and the proper use of the equipment.
2. The use of this product by children is forbidden.
3. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use
of the product by a person responsible for their safety.
4. Use only accessories with a permissible speed at least as high as the no-load speed of the
machine.
5. Do not use tool if damaged, eccentric or vibrating.
6. Always hold tool firmly to avoid kickbacks.
7. Never seize the chuck or bit during operation
8. Always stop the tool before putting it down (note: Ensure that chuck is no longer rotating when
you put down the tool)
9. If the power cable is damaged, it must be replaced by the manufacturer, its after sales service or a
person with similar qualification in order to avoid any danger.
If the power cable or extension cord is damaged or cut during operation, immediately disconnect
plug from its main power source. Do not touch the cable or extension cord before unplugging from
main power.
10. Do not attempt to change the selectors' position when motor is operating. This action may
damage the tool.
11.-
12.-
13. Hold power tool by insulated gripping surfaces, when performing an operation where the tool
may contact hidden wiring or its own cord.
Contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the
operator an electric shock.
A barrier guard shall be provided to prevent inadvertent contact with the moving parts.
14. Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with the tool's construction and design:
a. Damage to lungs if an effective dust mask is not worn.
b. Damage to hearing if effective hearing protection is not worn.
c. Health defects resulting from vibration emission if the power tool is being used over longer
period of time or not adequately managed and properly maintained.