Ce Declaration Of Conformity - Fermax PLUS-2 Manual De Usuario

Cod. 97845 V06_17
After 10 seconds without programming or quickly pressing the programming button, the
receiver will exit programming mode, issuing two acoustic signals of 1 sec.
USE OF THE RECEIVER
These receivers are designed for use as remote controls for garage doors. Their use is not
guaranteed for directly activating any other equipment different to that specified.
The manufacturer reserves the right to modify equipment specifications without prior notice.
IMPORTANT ANNEX
Disconnect the power supply before handing the unit.
In compliance with the European Directive low-voltage electrical equipment, we hereby inform
users of the following requirements:
· For units which are permanently connected, an easily accessible circuit-breaker device must
be built into the wiring system.
· This unit must always be installed in a vertical position and firmly fixed to the structure of the
building.
· This unit must only be handled by a specialised installer, by his maintenance staff or by a duly
trained operator.
· The instruction manual for this unit must always remain in the possession of the user.
· Terminals of maximum section 3,8mm2 must be used for the power supply connections.
· Use time delayed fuses.

CE DECLARATION OF CONFORMITY

Hereby, FERMAX ELECTRONICA, S.A.U., declares that this PLUS-2 ref.5252, PLUS-2B ref.5251,
is in compliance with the essential requirements of Directive RED 2014/53/UE and Directive
RoHS 2011/65/UE. See website www.fermax.com.
FERMAX Avd. Tres Cruces, 133, 46017 Valencia, Spain.
http://docweb2.fermax.com/docs/decconformidad/EN/F05251.pdf
http://docweb2.fermax.com/docs/decconformidad/EN/F05252.pdf
1248123/1.0
7