Identification Of The Unit - Coreco CAREL easy Manual De Uso

3. IDENTIFICATION OF THE UNIT

The unit, model and serial number are identified by means of the information displayed on the
registration or on the data sheet that appears on all the products.
Apart from the identifying data of the unit, information relating to the gas refrigerant and electrical
voltage to which the unit must be connected is also displayed.
4. START-UP
The unit, model and serial number are identified
by means of the information displayed on the
registration or on the data sheet that appears
on all the products.
Apart from the identifying data of the unit,
information relating to the gas refrigerant and
electrical voltage to which the unit must be
connected is also displayed.
• Once the inside of the unit is clean, connect
the power supply and place the switch in
the On or I position. The switch should be lit up.
• The thermostat display shows the air temperature inside the unit.
• Three minutes after turning on the switch, the LED showing the compressor is working will light
up permanently.
• The initial temperature that is shown on the thermostat display will be the ambient temperatu-
re. As the machine works, the temperature will reduce until it reaches its operating temperatu-
re.
• The units for storage of frozen foods are programmed to defrost two hours after starting opera-
tion.
• It is important that the unit runs until it reaches its operating temperature before proceeding to
load the unit with products.
REGISTRATION
19