Building Into The Kitchen Cabinet - Proline PLI36G-E-1 Manual De Instrucciones

PART 2.
INSTALLATION

BUILDING INTO THE KITCHEN CABINET

Figure A
! Before installation, read the instructions carefully.
! Fit the refrigerator in stable kitchen units only.
! If necessary, reverse the door according to instructions.
1. See fig.A for the necessary attachment components.
2. Insert trim flap
3. Pass the power cord through ventilation shaft and position it so that the appliance
can be easily plugged in once it has been installed. (fig.B - fig.C)
4. Take out the trim gasket
the rear of of the door hinges. (fig.D - fig.E)
5. Raise the appliance and slide into the kitchen unit.
6. Push the appliance to the rear of the door hinges, make sure that the trim gasket
covers the space between the appliance and the kitchen unit.
7. Align the front feet with front surface of the kitchen unit. (fig.F)
8. Secure the front feet by using screws
9. Screw trim flap
10. Screw guides
11. Place the appliance door against the cabinet door.
12. Slide rails (4)
13. Screw the rails
14. Set 1~2 mm gap on handle side between unit itself and unit door by adjusting
(3)
guides . That is vital for appliance performance. (fig.H)
(1)
into slot and secure using screws
(4)
located on the side panel of the appliance and stick it on
(1)
to kitchen unit using screws
(3)
to appliance door with screws
into guides (3) aligning the groove. (fig.H)
(4) to the unit door with screws
(6)
(5)
. (fig.F)
(5)
. (fig.G)
(6)
. (fig.H)
(5) . (fig.H)
UK - 16 -
. (fig.D)
(2)