S&P RADIANT-1505 Manual De Instrucciones página 13

1.7. This device must not be installed in an enclosed place where
air cannot circulate freely, both at the entrance and the exit.
1.8. Do not install the device immediately underneath a power
socket.
1.9. For fi xed electrical installation, disconnection means should
be included in accordance with installation regulations, with
contact separation at all poles that provides total disconnec-
tion under Category III overvoltage conditions.
1.10. This heater is Class II (double-insulated
does not require an earth connection.
1.11. The safety zones required by the local electrical installation
standards or safety regulations applicable in your country
must be strictly observed. In any case, if it is going to be ins-
talled in a bathroom, NEVER install it in the area indicated
as AREA 0, AREA 1 or AREA 2. As it is an IP21 rated device, it
can be installed in AREA 3, provided it is placed so that it is
NOT in reach of anybody who is in the bathtub or shower, this
including the device's power cord. (See FIGURE 3).
1.12. For mobile use, it can't be used near a bathtub, a shower or
a pool.
1.13. The power outlet where the appliance's power cord is con-
nected should be placed so that it is visible and easily acces-
sible to the user.
1.14. CAUTION: Some parts of this device may get very hot and
cause severe burns. Special care must be taken when chil-
dren and vulnerable persons are present.
1.15. Before plugging in the device, make sure the mains voltage
matches that indicated on the data plate.
1.16. Before plugging in / unplugging the power cable, make sure
the device's on/off switch (on the rear) is turned off.
1.17. Do not pull on the power cord to unplug it from the mains.
1.18. If the power cord is damaged, it must be replaced with a ca-
ble with the same plug.
) and therefore
13