Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
Gala hydromassage baths are manufactured using top quality materials. Before reaching its
destination, each hydromassage bath has been subjected to strict technical and safety controls..
In order to ensure the correct operation of your hydromassage bath, please follow the instructions
below:
1.The installation must be carried out by qualified personnel and in accordance with the current
regulations of each country.
2.The bath's protective elements must remain in place until the installation work has been completed in
order to prevent the risk of damage. The bath must be lifted by its frame, not dragged or lifted by its
pipes.
3. Before installing the bath, check that no damage has occured during transportation or handling.
The hydromassage bath must be installed in accordance with the INSTALLATION INSTRUCTIONS
corresponding to each model, which are enclosed with the bathtub, paying special attention to the
following points:
1. Before installing the bath, fill it with water and check that there are no leaks and that all the
hydromassage bath elements operate correctly.
2. When applying silicone respect the indicated measures in order to avoid the small vibrations that
can cause the motor of the bathtub during the normal functioning
THE BATHTUB MAY BE FRONTED IN TWO DIFFERENT WAYS:
1- MASONRY WALL
1.Take care to leave a 2-3 mm space between the bath
and the wall in order to be able to seal the joint with
silicone (Fig. 1).
2.The motor area must be enclosed, but accessible for
possible repairs. A grille must also be provided for
ventilation of the hydromassage bath equipment.
Installation manual - EMMA
INTRODUCTION
BATHTUB INSTALLATION
.
24 9
Tabla de contenido
