CMT ORANGE TOOLS POCKET-PRO PPJ-002 Manual De Instrucciones página 6

EN
1-1/8"
Angled and Beveled Joints
1"
The Pocket-Pro™ can be used to create a
7/8"
wide variety of angled and beveled joints. The
3/4"
unique incremental height adjustment of the 5/8"
1/2"
Pocket-Pro™ lets you put the pocket in the
best possible position for your application. As
you become more experienced with the jig you
will find many more applications than we can
possibly illustrate, but this 45° angled joint is
a good illustration of the technique:
1) This joint connects two pieces of 3/4"
(19mm) stock, but we recommend that
1-5/8"
1-1/2"
you set the jig at the 1" (25,4mm) height.
1-3/8"
1-1/4"
1-5/8"
1-1/8"
This has the effect of moving the pocket
1"
1-1/2"
7/8"
farther back from the end of the miter cut,
3/4"
5/8"
1-3/8"
1/2"
creating a stronger joint.
1-1/4"
1)
2) Drill the holes. If you are joining wide ma-
1-1/8"
terial, you will probably need more than
1"
two holes, so shift the stock in the jig as 7/8"
3/4"
needed.
5/8"
3) In order to assemble the joint, it will help
1/2"
to create a stop block as shown to hold
the work in position. This technique is use-
ful in many other pocket hole applications.
1-5/8"
Tongue & Groove and Rabbeted
1-1/2"
1-3/8"
Joints 1-1/4"
1-1/8"
1"
7/8"
3/4"
The Pocket-Pro™'s incremental adjustment
5/8"
1/2"
comes in handy for these common joints. Oth-
2)
er pocket hole jigs are positioned so that your
screw would cut through the tongue portion of
the tongue and groove joint.
By adjusting the height of the Pocket-Pro™,
however, you can control precisely where the
screw is positioned. For example, in this illus-
tration, we used 3/4" (19mm) material, then
showed where the screw would be positioned
at the commonly-used 3/4" (19mm) position
in the upper illustration. In the lower drawing,
we show the advantage of the 7/8" (22,2mm)
position with the Pocket-Pro™.
5)
6
1)
2)
mitered or angled joints. Try other
3)
Block clamped to workpiece
holds stock in position
Other pocket hole
jig set at 3/4"
(19mm) position
runs the screw
through
the tongue
Pocket-Pro™ set
at 7/8" (22,2mm)
position yields
a stronger joint
www.cmtorangetools.com
25,4mm (1")
The 1" setting is ideal for many
settings for various thicknesses.