Samsung WF56H9100A Serie Manual De Usuario página 16

installing your washer
step 3
Installing your Washer
To connect the water hoses to the faucets:
1. Connect one end of each water hose to the Hot or Cold tap.
2. Turn the fittings by hand until they are tight, and then tighten them by just
an additional two-thirds of a turn with a spanner. Do not overtighten the
fittings. You can damage them.
3. When done, pull the water hoses up and down to check if they are
properly connected.
4. Put the other ends of the hoses into a bucket and open the taps for 10-
15 seconds to remove impurities. When done, close the taps.
5. Tighten Coupling by hand until it is snug.
6. Then tighten two-thirds of a turn with pliers.
7. Run water in a bowl or basin to get rid of any debris inside hose. Check
for HOT and Cold water supply.
8. Connect one end of the COLD/HOT water supply hoses to the each
COLD/HOT water supply intakes at the back of the washer.
9. Tighten Coupling by hand until it is snug.
10. Then tighten two-thirds of a turn with pliers.
11. For proper operation, make sure both Hot & Cold hoses from faucets are
connected to the corresponding Hot / Cold water inlets on the washer.
(USER)WF56H9100-03404A-10_EN.indd 16
16_ English
A B
Rubber washer
HOT COLD
COLD (Left) HOT (Right)
Water Water
2016/8/18 11:31:46