Stihl MF-MM Manual De Instrucciones página 13

Changing the Deflector
Removing the Gearbox
1
2
1
Loosen the clamp screws (1) and
N
pull the gearbox (2) off the drive
tube.
Removing the Deflector
3
4
Loosen the screw (3) and pull the
N
deflector (4) off the drive tube.
MF-MM
Fitting New Deflector
5
7
7
Line up the deflector (5) on the
N
flange (6) and push it onto the drive
tube as far as stop.
Tighten down the clamp screws (7)
N
firmly.
Mounting the Gearbox
1
2
1
Push the gearbox (2) onto the drive
N
tube as far as stop while turning it
back and forth.
Line up the gearbox.
N
Go to "Checking Position of
N
Gearbox".
Checking Position of Gearbox
WARNING
To reduce risk of injury from the
MultiTool rotating in the wrong direction,
check that position of gearbox is correct
and adjust if necessary.
6
The axle (1) must be below the shaft (2).
Direction of rotation (3) of MultiTool.
Adjusting Position of Gearbox
Loosen clamp screws on gearbox.
N
Turn the gearbox through 180°.
N
Line up the gearbox in the correct
N
position.
Tighten down the two clamp screws
N
on the gearbox in the following
sequence:
English
11