Transport And Storage; Installation; General Installation Notes - Schluter Systems BEKOTEC-THERM-RTBR Instrucciones De Montaje

GB

4. Transport and storage

Transport the product in its original package. Store the product at the following conditions:
Temperature range
Relative humidity
Particles
Mechanical impact
Radiation
Chemical influences

5. Installation

5.1

General installation notes

Please note the following prior to installation:
• The lower edge of BEKOTEC-THERM-RTBR / RTB must be at least 20 cm above the finished floor.
• The front edge of BEKOTEC-THERM-RTBR / RTB must be in the same plane as the finished wall.
If the wall is not yet completed, take the space taken up by plaster or tiles into account for the assembly.
• The opening of the installation box must point downwards.
• The thermostat may not be influenced by external heat sources.
• Use the supplied angle template for aligning and attaching BEKOTEC-THERM-RTBR / -RTB.
Material damage caused by lubricants!
The use of grease or oil can destroy seals.
Do not use any grease or oil for installation.
Caution
If applicable, flush particles of dirt as well as grease and oil residue from the pipe system.
Note the state of the art (e.g. VDI 2035) when selecting the operating medium.
28
-20 °C to +60 °C
max. 95%
Dry and protected against dust
Protected against mechanical vibration
Protected against UV radiation and direct sunlight
Do not store together with solvents, chemicals, acids, fuels etc.
i
Transport and storage / installation
1
Masonry
2
Schlüter -BEKOTEC-THERM-RTBR / RTB
®
3
Installation box
4
Plaster
5
Edge insulation strip
6
Screed
7
Conduit
Fig. 14: Installation cross-section