ENGLISH
NOTE
The filter strainer (B) must be correctly positioned on the housing (E) of the support (A).
SQUEEGEE BLADE CHECK AND REPLACEMENT
Clean the squeegee as shown in the previous paragraph.
Check that the edge (M) of the front blade (D) and the edge (L) of the rear blade (E) lay down on the same level, along
their length; otherwise adjust their height according to the following procedure:
− Disengage the retainers (A) to adjust the rear blade (E); then engage the retainers.
− Loosen the handwheels (G) and adjust the front blade (D); then tighten the handwheels.
Check the front blade (D) and rear blade (E) for integrity, cuts and tears; if necessary replace them as shown below.
Check that the front corner (N) of the rear blade is not worn; otherwise, overturn the blade to replace the worn corner with
an integral one. If the other corners are worn too, replace the blade according to the following procedure:
− Disengage the retainers (A) and remove the retaining strip (B), then replace/overturn the rear blade (E). Install the
blade in the reverse order of removal.
− Unscrew the handwheels (G) and remove the retaining strip (H), then replace the front blade (D). Install the blade in
the reverse order of removal.
After the blade replacement (or overturning), adjust the height as shown in the previous step.
Connect the vacuum hose (32) to the squeegee.
Install the squeegee (12) and screw down the handwheels (13).
If necessary, adjust the squeegee adjusting handweel(13).
24
USER MANUAL