Delta BS150LS Manual De Instrucciones página 10

4. Re-assemble the locking lever stud (g) Fig. 1
through the trunnion slot (L) and tighten with the
table locking lever handle (see inset).
5. Fig. 13 shows the table locking lever disassembled
(removed in STEP 1). Item (B) is a M10 flat washer,
(g) stud, (A) Locking Lever, (E) spring, (D) shoulder
screw, and (C) 4mm hex wrench.
6. Re-assemble the screw (D) Fig.13A and tighten using
4mm hex wrench provided.
A
B
g
Fig. 13
7. Fig. 14 shows the disassembled table tilt pinion knob
(N) , spring (O), and special screw (P), removed in
STEP 1.
8. Re-assemble the table tilt pinion knob (N) Fig.
15, on the back of saw so that the teeth on the
pinion knob (N) engage the teeth on the trunnion
(R). Fasten in place with the special screw (P) and
spring using the 4mm wrench provided.
C
E
D
L
R
N
10
10
Fig. 12
D
Fig. 13A
N
O
P
Fig.14
P
Fig.15
g