Priorit AS32 Serie Manual De Instrucciones página 24

Installing the Suspension File Pull-out:

Screw the suspension file pull-out into the pre-drilled holes in the support bracket using 4.5 x 25 mm
screws

Adjust the suspension file pull-out (approx. 15 mm from the upper edge of the support bracket)

Screw down the suspension file pull-out, using all available pre-drilled holes
Mounting a Narrow Suspension File Pull-out: (AS32-HRA-S)
single-side installation
SB A

For single-side installation use 6 x 40 mm screws to attach support bracket A (SB A)

For parallel installation of SB A: screw down using M4 x 55 mm screws and sleeve nuts

Pull-out in models with a centre partition: use the enclosed 4.5 x 20 mm screws

Attach to the side walls of the cabinet as described in "Installing the support brackets"
EP.V.9906-3
AS32-XXX-MW-X
4.5 x 25 mm
parallel installation
SB A SB A
24 von 88