Technical Specifications; Important Warnings; Instructions For Use; Maintenance - Henry Schein LAB VIBRATOR small Instrucciones De Uso

2

TECHNICAL SPECIFICATIONS :

Casing
Dimensions
(width x depth x height)
Plate DImensions
Voltage
(VERIFY THE INDICATION ON THE EQUIPMENT LABEL)
Max absorbed power
Weight (approx.)
Power regulator for the modification of the vibration intensity two way switch

IMPORTANT WARNINGS :

(1) Check to see that the main voltage corresponds to the power requirements for the
unit as specified on the identification label.
(2) During the vibration the material on the vibrator could overflow. Avoid any spillage of
material from the rubber plate in to the machinery as this could result in damage.

INSTRUCTIONS FOR USE :

(1) Check to see that the main voltage corresponds to the power requirements for the
unit as specified on the identification label. Plug cable into machine and power
socket.
(2) On Lab Vibrator medium select the desired vibration by using switch (17) while the
machine is switched off.
(3) To start vibrator use on/off switch (16).
(4) Adjust the vibration level by means of the knob (15).
(5) Place the ring with the material to be vibrated on the rubber place for the desired
time.

MAINTENANCE :

(1) The vibrators require minimal maintenance apart from occasional cleaning of the
rubber plate. This should be carried out with the rubber plate removed from the
vibrator.
LAB VIBRATOR S
Steel housing with
baked-enamel finish
17 x 17 x 8,5 cm
16 x 15,5 cm
230Volt/50Hz or
120Volt/60Hz
100 Watt
kg 3,3
for lower and higher vibration (on Lab Vibrator M only)
LAB VIBRATOR M
Steel housing with
baked-enamel finish
24 x 15,5 x 10 cm
22,5 x 14 cm
230Volt/50Hz or
120Volt/60Hz
200 Watt
kg 5,1
LAB VIBRATOR L
Steel housing with
baked-enamel finish
35 x 25 x 13 cm
34 x 24 cm
230Volt/50Hz or
120Volt/60Hz
350 Watt
kg 8,7