General Notes; Description Of The Equipment And Its Use - Henry Schein LAB VIBRATOR small Instrucciones De Uso

GENERAL NOTES :

Please read this booklet carefully. It contains important information about safe installation,
use and maintenance. Keep this booklet in a convenient place for further reference.
(1) Check the general condition of the unit after removing the packaging. When in doubt
do not operate the unit and contact a qualified service repair person authorised by
HENRY SCHEIN.
(2) Before connection, check to see that the identification plate indicates the correct
voltage for the electrical supply system. lnstallation must be carried out in compli-
ance with all applicable safety standards and in accordance with the manufacturer's
instructions. The manufacturer will not be held responsible for damage to objects
and/or harm to people caused by improper installation.
The unit is safe only when connected correctly to ground via an appropriate device
in accordance with safety standards.
This fundamental requirement must be satisfied. If in doubt, request a thorough
inspection of the system by a professionally qualified technician.
The manufacturer will not be held responsible for damage caused by an improperly
grounded system.
(3) This unit should only be used as intended by the manufacturer. Any other use must
be considered inappropriate and consequently dangerous. The manufacturer will not
be held responsible for damage caused by improper, erroneous or unreasonable use.
(4) Switch-off and unplug the unit from the electrical outlet before servicing.
(5) Carefully follow cleaning instructions as in the manufacturer's manual.

DESCRIPTION OF THE EQUIPMENT AND ITS USE :

The vibrators of the LAB VIBRATOR series have been developed for vibrating and com-
pacting investments, plasters or similar materials. This procedure improves the homo-
geneity of the product and eliminates air bubbles that could be generated while mixing
and melting the product.
The LAB VIBRATORS are equipped with an easy to remove rubber plate to facilitate
cleaning and a power regulator which allows continuous change to the vibration inten-
sity from minimum to maximum. The LAB VIBRATOR medium model is also supplied
with a two-way switch for selecting a lower and a higher vibration.
The LAB VIBRATOR series consists of 3 different models with different dimensions and
powers:
LAB VIBRATOR small:
LAB VIBRATOR medium:
LAB VIBRATOR large:
plate 16 x 15,5 cm;
plate 22,5 x 14 cm;
plate 34 x 24 cm;
max 100W
max 200W
max 350W
1