Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
ATTACHING AND REMOVING THE BLOWER/VACUUM TUBE
Attaching
NOTE: The blower/vacuum tube comes unassembled on this unit. Installation is required to provide safe
and easy use for the operator.
1, remove the screws and nuts provided from the hardware pack.
2, insert the blower/vacuum tube all the way into the opening on the motor housing until the holes in the
tabs on the blower/vacuum tube align with the screw holes in the housing (fig.1 )
3. Insert the 2 (two) 8-32x3/4" slotted T20 screws into the right side of the motor housing and the 2(two)
nuts into the left side of the motor housing (Fig. 2)
4. Tighten the screw firmly. Do not over-tighten.
5. Install the 2 (two) remaining self-tapping 8-16x3/4" slotted T20 torx screws into the holes on either side
of the housing (Fig. 2) tighten until snug. Do not over-tighten.
Removing
WARNING: To prevent serious personal injury. Stop the engine and allow the impeller to stop
before attaching or removing tubes.
1. Remove the 2(two) self-tapping screws from side of the housing
2. Remove the 2 (two) screws and nuts holding the blower/vacuum tube on the
housing (Fig. 1)
NOTE: Keep the hardware in a safe place for future use.
3. Remove the blower/vacuum tube from the motor housing.
4. Replace the blower/.vacuum tube before use.
ATTACHING AND REMOVING THE VACUUM BAG
Attaching
1,
Attach
the vacuum bag to the vacuum bag hook on the blower vacuum tube (Fig. 3)
2. Slide the vacuum bag tube over the debris exhaust tube on the housing. Push the tube until the
latching tabs on both sides click into place. Securing the bag on the unit (Fig. 4)
Removing
1. Press the latching tabs on both side of the vacuum bag tube and pull the vacuum bag from the unit
(Fig. 5)
2. Detach the vacuum bag from the vacuum bag hook.
P-10
Tabla de contenido
