Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.
You can switch between the low and high power level during operation using the button
•
Low power level: Indicator
•
High power level: Indicators
4.
You can switch on the power saving mode during operation by pressing the button ECO . The indicator
turns on.
ECO mode: The default temperature is 22°C, when the temperature drops under 18°C the high power
•
level turns on, when the temperature increases over 18°C, the appliance switches to low power level.
When the temperature reaches 22°C, the heater turns off.
5.
Press
to turn on or off the rotation of the appliance. During rotation the indicator
the rotation is turned off the indicator is off.
6.
Press
to set timer or temperature.
Setting the timer
•
Using button
switch between temperature setting and timer setting.
•
Press
to enter the timer setting mode. The indicator
the timer using buttons (+) and (-) in the range 0-24h. Each time you press (+) / (-) you move the time by
1h. Press and hold (+) / (-) to change the values faster.
•
If the displayed value is different from 0, the countdown of the timer starts and once it reaches 0 the
appliance switches to standby mode.
•
If you do not press any button or if you press any other button than (+) / (-) within 5 seconds, the timer
setting stops and the display shows the room temperature.
•
When you finish the timer setting, press
Temperature settings
•
Using button
switch between temperature setting and timer setting.
•
Press
to enter the temperature setting mode so that the indicator
temperature using the buttons (+) and (-) in the range 15°~35°C. You change the temperature with each
pressing of (+) / (-) by 1 °C. Press and hold (+) / (-) to change the value faster.
•
Press
to exit the temperature setting mode, the appliance will hold the temperature you have set.
•
If you do not press any button or if you press any other button than (+) / (-) within 5 seconds, the timer
setting stops and the display shows the room temperature
•
The forst 10 seconds after you switch on the appliance, the temperature check is not performed. If the
ambient temperature is higher than the set temperature within 10 seconds from switching the appliance
on, the heater switches off, the indicator of high and low power mode turns off and the fan stops in
10 seconds. If the rotation function was active, the rotation stops as well. Other indicators and functions
do not change. Once the ambient temprature drops by 2 degrees under the set temperature, the heater
starts again, as well as the fan and rotation (if the roration function was active before).
Note:
If the timer and the temperature are set in the same time, the display will alternate every 30 seconds between
showing the temperature and the timer value. If the timer is not set, the display will show only the temperature.
Attention:
If you want to turn off the heater, always turn it off using both switches (on the control panel and the switch
0/I).
is on, indicators
and
and
are on.
to go to the temperature setting.
are off.
flashes on the display and you can now set
turns on. You can change the
.
is on. When
GB
35
35
35
Tabla de contenido
