Beper PTC Manual De Instrucciones página 12

PTC Convector Heater Use instructions
Wall mounting Fig. 2
1.Assembly: The heater should be situated at least 1.8 meter above the floor.
2.The plug and power cord should be installed on height unavailable for children.
3. You need the following for installation: 2 soft inserts, 2 screws, 4 gaskets (all mentioned you will
find in gift box).
4.Please, insert the gaskets into the holes in body.
5.You should make the holes in the wall on 57cm from each other horizontally and at least on 2 m
over the floor. This way the heater should be at least on 1.8 m from the floor level.
6.The depth of the holes in wall should be 42-45 mm, of 8 mm diameter. The tighten screw should
be protruded from the wall on 18-20 mm.
7.After the heater installation, you should tighten the screws.
Operation
1. Carefully remove the heater from the plastic bag and the carton.
2.Place the heater on the wall.
3.Setting the master button to "off". plug the cord set into a 230v~AC electrical outlet. Turnning the
master button "on" position.
4.Push the heater ON by pressing the ON/OFF button .The unit will display the current Room tem-
perature, automatic into "FAN" mode, and blow the natural wind.
5.Push the button "ON/OFF"button ,the unit will be set in the lower heating mode
6.Push the " ON/OFF" button a second time, the unit will be set into higher heating model.
7.Push the "ON/OFF" button a third time will be set into SWING mode.Push once again, it will blow
cool air and indicator light lighting.
8.To turn the heater OFF , press the ON/OFF button.
This function will work in any mode. The timer function allows you to set the length of operation
from 0.5 hour to 7.5 hours. Pressing the Timer button increase the length of operation by 0.5 hour
each times the button is pressed. Once the timer has been set the timer will count down the hours
in 0.5hour by 0.5 hour , showing on the display the remaining operating time until the heater will turn
itself off. Pressing the timer button once more after the display reflects 7.5 hours will reset the heater
to continuously running
Remote control
1.Install two "AAA"(not included) batteries as shown
2.The remote control power button is labeled as such
3. All the functions performed with the remote control work identically to the manual controls.
Cleaning and maintenance
Unplug from the outlet before cleaning. Allow to cool before cleaning the appliance. To clean the
surface use the soft wet cloth(or cloth with some scour). Make sure that do not pour water on to the
appliance. Do not use any organic solvents such as gasoline and toluol.
If you do not use the appliance for a long time, wipe off the surface and store the appliance in the
orginal packing box at a well ventilated place. Avoid dampness and impacts.
12