How To Remove And Install Pull-Out Drawer - LG LFXS24663 Manual De Usuario

HOW TO REMOVE AND INSTALL THE PULL
OUT DRAWER (3 DOORS MODELS).
1. Removing Pull out Drawer
IMPORTANT: To avoid possible injury, product or
property damage, you will need two persons to
perform the following instructions.
To remove the drawer, push the tabs located on
the front inside surface of each rail. Then gently
lift the rear left and right sides of the drawer and
pull it out (Fig. 1)
Fig. 1
To reinstall, pull out and fully extend both rails.
Insert the end of rib in the bracket at left and
right. Making sure that the guides at the front
are lined up properly, gently push down on both
sides (Fig. 2)
Fig. 2
Pull the drawer open to full lower extension.
Remove the durabase by lifting it from rail system.
(Fig. 3)
Fig. 3
REFRIGERATOR INSTALLATION
Durabase
12
Remove the screws of the rail on both sides.
(Fig. 4)
Fig. 4
CAUTION: When removing drawer door, do not
hold it by the handle. The door could fall down
and you may be injured. Grasp the door with both
hands as pictured below when removing.
CAUTION: When laying down the drawer, be
careful not to damage the floor or hurt your feet
with the sharp edges on hinge side.
With both hands, hold both sides of the door
(Fig. 5) and pull it up to separate it from the rails.
(Fig. 6)
Fig. 5
Fig. 6
screw
Door
supports
Rail tabes