Triton Blue ArtNet-DMX 8 Manual De Usuario página 12

a n dMx
rt et to
When the unit is used as an ArtNet to DMX adapter, Art-Net universes must be assigned to DMX output
ports, and the Net, Subnet, IP address settings must be configured.
To configure Net and Subnet setting, do the followings:
1) Press button until
2) Use
3) Press button to access
select output Type
4) Press
and Subnet.
dMx s
plitter function
When the unit is used as a DMX splitter only, DMX output ports must be assigned to either DMX IN-1 or
DMX IN-2, the Net, Subnet, IP address settings do not need configuration.
1) Press button until
2) Use
3) Press button to access
assign port selected to DMX IN-1 or DMX IN-2
a n -dMx
rt et and
When the unit can be used as both ArtNet-DMX adapter and DMX splitter simultaneously. In this case,
both ArtNet settings and DMX assignmets must be configured. Please refer to ArtNet to DMX and DMX
Splitter function.
DMX output ports can be assigned to only ArtNet or DMX -1/2, not both.
Note: when an output is set to DMX Hold, it will keep sending DMX signal of last status
when Artnet or DMX input is lost
12.
System Setup
[ new software ]
button to select System Setup
[ Outputs Set]
Port Type
[01] Art-Net
Port Type
01 [Art-Net]
Net Subnet
button to access
[000]
System Setup
[ new software ]
System Setup
button to select
[ Outputs Set]
Port Type
[01] DMX-1
dMx s
pliter function
User Manual | ArtNet-DMX 8Triton Blue | Rev. May.2015 | www.triton-blue.com
shows in the display.
, use UP/DOWN to select Port and
then use
001
shows in the display.
, use UP/DOWN to select Port and
Port Type
3 [DMX-2]
button to
and button to set Net
button to